Crane EE-6353 Dokumentacja Pobierz pdf (Strona 8)

4 EC6000 Owner’s Manual

Installation Overview

1. Determine that the mounting location for the EC6000 crane is at least 18” x 20” (45.7 x 50.8 cm).

2. Use the detail below to drill 1.06” diameter holes into the mounting plate. Run tap on the threads of the

base to be sure they are clean.

3. Use a crane or lifting device capable of lifting the weight of the Stellar crane. The Stellar EC6000 weighs

approximately 1600 lbs (725 kg). Note: cranes are shipped with rotation positioned at 200 degrees of 400

degree system. This will allow for easy installation of the crane and permanent connection of all hydraulic

and electrical components prior to repositioning into the crane saddle.

4. Connect straps or chain from the lifting device to the lifting rings on the Stellar EC6000.

5. Use four (4) 1” x 3” Grade 8 bolts and four (4) 1” Grade 8 flat washers.

6. Install a washer on each bolt.

7. Apply Loctite Thread locker #277 to the bolts.

8. Using the lifting device, lower the Stellar EC6000 just above the crane compartment and start the bolts.

Have someone assist in leveling the crane. Note: the rotation motor should be to the door side of crane

compartment and the boom should be extended back over the rear bumper.

9. Secure the crane using the mounting hardware provided. Note: longer or shorter bolts may be required –

recommended thread engagement into crane base is 1.75” – use grade 8, zinc plated bolts only.

10. Torque the bolts to 680 ft-lbs.

11. Remove supporting crane.

12. Hook-up hydraulics and electrical using the schematics provided in this chapter.

Note: If questions should arise during any portion of this installation,

please contact Stellar Customer Service at (800) 321-3741.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 25 26

Brak uwag

Crane EE-6353 Dokumentacja Strona 8